10/6/2017: Marine Safety Alert 11/17: Remain upright by fully understanding vessel stability

Submitted by the Office of Inspections & Compliance (CG-5PC)

The Office of Inspections and Compliance issued Marine Safety Alert 11/17: Remain upright by fully understanding vessel stability.

This safety alert addresses concerns related to vessel stability and watertight integrity. Recently, a marine casualty involving a fishing vessel in the Bering Sea resulted in multiple fatalities and complete loss of the vessel. A Marine Board of Investigation is currently analyzing the various circumstances surrounding the casualty. Although the investigation is not complete, testimony and fact finding indicate that vessel owners, operators, and crews should give special consideration to vessel stability concerns.

The need for operators to understand their vessel’s Stability Instructions (SI) cannot be overstated. It is important to understand the document. Operators and crew should seek out opportunities to further their knowledge of stability via courses, training, workshops, and visits from Naval Architects. They should also take advantage of other various initiatives, both mandatory and voluntary, to discuss and compare a vessel’s current SI to the actual loaded condition prior to departing port. An independent review of a vessel’s loaded condition, equipment, and operations can often provide important insights.

Operators can significantly reduce the risk of capsizing by performing the following actions:

  • Routinely review and update vessel SI
  • Stay below the limits for vessel and cargo detailed in SI
  • Ensure SI reflect the vessel’s current arrangement, equipment, and operations (lightship and loaded cargo/fishing gear conditions)
  • Follow good marine practice by re-assessing the SI every five years

 

Operators should confirm the accuracy of their SI whenever a vessel undergoes any of the following actions:

  • Major conversions or substantial alterations (See 46 CFR 28.50 and 28.501, respectively)
  • Changes to a vessel’s rigging, deck, or fishing equipment (including pots)
  • Changes in principal dimensions, cargo hold, or tank capacities
  • Circumstances of weight creep (i.e., the accumulation of extra gear, equipment, and parts carried aboard the vessel)
  • Any other weight change variations which may occur

 

Carry pots?

  • Pay special attention to pot weights
  • Annually weigh a percentage of them to verify if the actual weight (including shots of line and buoys) matches that recorded in the SI
  • Weigh them wet – soaked lines can add as much as 15 pounds per shot
  • Consult a Naval Architect for loading recommendations and amendments if pots are heavier than what is listed in the SI.
photo of pots on the deck of a fishing vessel

Pots can significantly impact a vessels stability if not properly calculated.

Icing makes a vessel dangerously unstable:

  • Regulations for SI assume only 1.3 inches of accumulation on horizontal surfaces
  • Real life conditions easily and often exceed 1.3 inches of icing
  • Unless tested for a value over 1.3 inches a vessel’s capsizing and sinking risk increases when that value is exceeded on horizontal surfaces
  • A vessel’s center of gravity can rapidly rise when freezing spray accumulates high above the main deck
  • Operators should use all available resources to determine if icing and freezing spray is forecasted in their operational location for the next 48-72 hour time window
  • If icing conditions are forecasted or present – operators should seek shelter, reduce speed, change course, and
    manually remove ice
  • If forecasted prior to departure, operators should consider reducing the amount of bait, gear, and pots.
Photo of fishing vessel covered in ice.

Real life conditions easily and often exceed 1.3 inches of icing.

Operators should perform the following actions to maintain watertight integrity:

  • Follow SI associated with watertight doors (WTDs) and hatches
  • Frequently train and inform crew to habitually close watertight doors and hatches at sea
  • Label WTDs to be closed
  • Keep hatches closed to the greatest extent possible
  • Practice closing WTDs that are routinely permitted to be open during emergency drills.

 

Important vessel stability training hyperlinks:
Online Stability Training
Stability Guide
Stability Card Sample
Stability Log
Stability Modification Sample

This safety alert is provided for informational purposes only and does not relieve any domestic or international safety, operational, or material requirements. Developed by a Coast Guard Marine Board of Investigation in conjunction with Coast Guard District 13 and 17 Prevention Divisions. Questions may be sent to HQS-PF-fldr-CG-INV@uscg.mil.

 

This blog is not a replacement or substitute for the formal posting of regulations and updates or existing processes for receiving formal feedback of the same. Links provided on this blog will direct the reader to official source documents, such as the Federal Register, Homeport and the Code of Federal Regulations. These documents remain the official source for regulatory information published by the Coast Guard.

Comments

comments

Tags: , ,